Xerox Versant 4100 Press - Setting Up Media with a Custom Barcode in Offline Mode

3. To print the barcode, click Print Barcode.
Note: If you want to print the custom barcode, load Letter or A4 size paper in any tray
other than the one you are currently programming with the stock. If no Letter or A4 size
paper is loaded in the press, you cannot print the barcode during the setup process in the
wizard. You can also print your custom barcodes from the PredictPrint Stock Library at any
time.
4. To scan the barcode as needed in the future, keep the printed barcode for reference.
5. Click Accept and Next.
The Stock Wizard starts a series of automatic setup routines.
6. The Stock Wizard performs the recommended automatic setup routines. After each setup
routine, click Accept and Next. The automatic setup routines include the following:
• Tray Programming
• Basic Alignment Setup
• Secondary Transfer Voltage Adjustment
• Calibration and Profiling: This automatic setup is performed after the semi-automatic
adjustments, and before any manual adjustments.
Note: It is important to remember that these setup routines and all of the other print
engine adjustments are performed only if needed. If the PredictPrint Cloud Server
Intelligence determines that they are not needed, the PredictPrint Stock Wizard skips them.
7. At any time during the process, to change the information on the previous screen, click Go Back.
8. At any time during the process, to cancel the stock setup routines, click Cancel Setup.
Note: The Cancel Setup option stops any additional setup routines from running in the
wizard, at that time. Cancelling setup routines does not cancel the assignment of the stock
to the tray.
9. To go to the next setup routine, click Accept and Next.
Setting Up Media with a Custom Barcode in Offline Mode
When the stock does not have a barcode and the press is not connected to the Internet, the Stock
Wizard cannot communicate with the PredictPrint Cloud Server to generate a barcode. Before you
generate a custom barcode, ensure that you have a portable USB storage device.
Note: If the press is not connected to the Internet, you can download the Stock Lists from the
PredictPrint Cloud Server. To download the Stock Lists from the PredictPrint Cloud Server, refer
to Downloading a Stock List from PredictPrint Cloud Server.
1. On the Stock Wizard Setup screen, select a Paper Edge Feed option:
• Long Edge Feed
• Short Edge Feed
2. Click Next.
3. To get a barcode and complete the stock setup, insert a USB storage device into the Fiery Print
Server. Click Copy Stock File.
4. Save the stock file on the USB storage device.
Xerox
®
Versant
®
4100 Press
User Documentation
95
Working With