Xerox Versant 4100 Press - Page 134

5. Select the desired curl correction setting:
• Default
• Type A
• Type B
• Type C
• Custom Curl Correction:
• Severe (Large) Upward
• Medium Upward
• Moderate (Small) Upward
• Slight (Very Small) Upward
• No Curl
• Slight (Very Small) Downward
• Moderate (Small) Downward
• Medium Downward
• Severe (Large) Downward
Important: If selecting one curl correction setting does not correct the paper curl, then
select another setting. It may take several attempts to correct the paper curl. Therefore, it
is recommended that you use the curl correction settings in the sequential order listed in
Recommended Order for Using Paper Curl Correction Test Print Options.
6. Select Test Print.
The Test Print - Paper curl correction Tray [1-3, 5, 6-7, 8-9] window opens with secondary test
print options.
7. Select the following:
• The paper tray (if applicable)
• The desired test print quantity
• The desired Front Print Density setting
• The desired Back Print Density setting (if the 2 Sided option was selected)
• Long Edge Feed or Short Edge Feed
8. Select Start.
An Information window displays stating Test Print in Progress.
Upon completion of the test prints, the Tray [1-3, 5, 6-7, 8-9] Paper Curl Correction Test Print
window reopens.
9. Retrieve the test prints from the output area of the press.
134
Xerox
®
Versant
®
4100 Press
User Documentation
Working With