5. Locate the fuser identifier clip on the fuser assembly and, using a marker, write on the identifier
the fuser width being used.
6. Locate the two bypass fuser connectors in the kit. The black resistor jumper (left) is used for the
number 2 range value and the blue jumper (right) represents the number 3 range value. For the
range numbers, refer to the bypass connector table in Fuser Paper Width Information.
7. Attach the appropriate jumper to the exposed white connector at the front of the fuser assembly
by pushing the two ends together. There is no release. To disconnect, simply pull apart.
8. Position the fuser front cover on the assembly and screw tightly in place.
9. Close the left and center front doors of the press.
Note: If the paper in the print job does not match the width set for the fuser, an error
message displays and the job does not print. Cancel the job and submit the correct paper
width for that job or change fusers so that the correct width-range fuser is installed.
260
Xerox
®
Versant
®
4100 Press
User Documentation
Working With
To Next Page
Loading...
