Xerox WorkCentre 7132

9 Paper and Other Media
210 Xerox WorkCentre 7132 User Guide
1. Pull out the paper tray towards
you.
NOTE: To avoid jams and misfeeds,
do not load paper on top of any
remaining paper in the tray. Remove
the paper, and reload it on top of the
new stock loaded.
2. If required, move the paper tray
guides further out to load the
new stock.
To adjust the side and rear guides,
pinch the guide lever on each guide
and slide the guides to their new
position.
To secure the guides in position,
release the levers.
NOTE: When changing the size or type of stock in the tray, refer to Paper Tray
Settings in the Setups chapter on page 225. For more information on reprogramming
the tray, contact the Key Operator.
3. Load the paper neatly and tightly
against the left-hand side of the
tray.
NOTE: Do not load paper above the
maximum fill line.
NOTE: When making single/double
sided copies on perforated paper,
load the paper so that the opposite
side to the perforations feeds first.
Feeding the perforated edge first may cause paper jams.
4. If the paper guides have been
moved, slide the guides to just
touch the edge of the paper.
NOTE: When loading standard size
paper, set the guides onto the
notches on the tray to match the
paper size. The machine recognizes
8K/16K paper as standard size even
though paper trays have no notches
for these sizes.
Downloaded From ManualsPrinter.com Manuals