Xerox WorkCentre 7132 User Guide

Changing the Default Time Settings
Xerox WorkCentre 7132 User Guide 41
is pressed, or a fax or print job is received by the machine. The factory default setting
of 60 minutes is customer changeable within the range of 1 to 240 minutes, and must
be longer than the Low Power Mode time value. The time specified for entering the
Sleep Mode will be counted from when the machine enters the Low Power Mode.
For more information, refer to Auto Power Saver in the Setups chapter on page 222.
Changing the Default Time Settings
This section describes how to change the default time settings using the Key Operator
access. If you need assistance or more information, contact the Key Operator or refer
to Machine Clock/Timers in the Setups chapter on page 221.
1. Press the <Log In/Out> button
on the control panel.
2. Enter the Key Operator ID using
the numeric keypad on the
control panel. Select [Confirm]
on the [User Login] screen.
NOTE: The default Key Operator ID
is “11111”. If the Authentication
feature is enabled, you may be required to enter a password. The default password is
“x-admin”. The password is case sensitive.
3. Select [System Settings] on the
[System Administrator Menu]
screen.
4. Select [System Settings] on the
[System Settings] screen.
<Log In/Out> button
Downloaded From ManualsPrinter.com Manuals

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English