10 Setups
276 Xerox WorkCentre 7132 User Guide
NOTE: When setting the box selector feature, select a mailbox that has already been
registered. If an unregistered mailbox is selected, the received document is
automatically printed instead of stored in a mailbox.
Memory Full Procedure
Specifies the default process to execute if the hard disk becomes full while reading
documents. A message asking how to process the data read up to that point is
displayed. You can predefine a processing method to be performed after the message
has been displayed for a specified period. If you select [Cancel Job], the data will be
discarded. If you select [Run Job], the data read up to that point will be processed.
Maximum Stored Pages
Specifies the maximum number of pages that can be stored in memory when you copy
documents. Select a number in the range from 1 to 999.
Mailbox Receive Display Priority 1 to 3
Specifies the display priority to the fax documents in the mailboxes. Select from [F
Code], [Remote Terminal ID], and [Remote Terminal Name].
File Destination/Output Destination
This feature allows you to sort received documents by incoming line to specified
mailboxes or to the output trays.
1. Select [File Destination/Output
Destination] on the [Fax Mode
Settings] screen.
2. Change the required settings.
3. Select [Close].
File Destination - Line Setup
Specifies the mailbox for storing received documents sorted by the incoming line. Up
to 200 mailboxes can be registered.
NOTE: Before using this feature, select [Enabled] in the [Box Selector - Line Setup]
feature on the [Fax Control] screen.
Line 1, 2, and 4
Specifies whether the incoming documents on this line are stored in a mailbox. Select
[On] to display the [Mailbox Number].
Output Destination - Line Setup
Specifies the output tray for printing received documents sorted by the incoming line.
The output tray for [Mailbox Printed Documents] can also be set.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
