Fax Mode Settings
Xerox WorkCentre 7132 User Guide 275
5.0 inches) using the scroll buttons or the numeric keypad on the control panel. We
recommend you use this feature with the following [Auto Reduce on Receipt] feature.
Auto Reduce on Receipt
Specifies whether to reduce and reproduce an image onto a single page if the received
document length exceeds the length of the loaded paper, but is within the value set in
the Border Limit feature. We recommend you use this feature with the [Border Limit]
feature. If this feature is set to [No] and the document length exceeds the paper length,
image loss may occur.
2 Pages Up On Receipt
Specifies whether to print two consecutive received documents onto one page. It is
effective in saving paper. If the number of received pages is odd, a blank page will be
add at the end. If the sizes of received pages are different, the larger size will be used.
NOTE: If the same size paper as the received document size is available, that paper
will be printed even when you set this feature to [Yes].
2 Sided Printing
Specifies whether to print received documents or private mailbox documents onto both
sides of a sheet. This is effective in saving paper.
NOTE: Some data may not allow you to use this feature even when you set it to [On].
Edge Erase - Top & Bottom Edges
Specifies the margin on the top and bottom of the received document by cutting off the
original image. You can set the margins within the range of 0-20 mm (0-0.8 inches)
using the scroll buttons or the numeric keypad on the control panel.
Edge Erase - Left & Right Edges
Specifies the margin on the left and right of the received document by cutting off the
original image. You can set the margins within the range of 0-20 mm (0-0.8 inches)
using the scroll buttons or the numeric keypad on the control panel.
Reduce 8.5×11” SEF Original to A4 SEF
Specifies whether a 8.5 × 11.0 inches (216 × 279 mm) size document is to be reduced
to the A4 size when [Reduce/Enlarge] in the [Layout Adjustment] screen is set to [Auto
%].
Pseudo-Photo Gradation Mode
Specifies whether to perform gradation level correction for documents containing
photographs. Select from [Error Diffusion] and [Dither].
Box Selector - Line Setup
Specifies whether to sort the received documents to the mailboxes by the incoming line
when more than one line is in use.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
