Xerox WorkCentre 7132 User Guide

Storing and Handling Paper
Xerox WorkCentre 7132 User Guide 213
When not in use, the paper trays can be opened and paper can be loaded while the
machine is running. However, do not open the active tray. This will cause the machine
to stop the job being processed.
Storing and Handling Paper
Always use high-quality, xerographic-grade paper in the machine. Damaged, curled, or
damp paper can cause jams and image quality problems. Follow these simple rules to
store paper.
• Store paper in dry conditions, away from extreme heat or cold, such as radiators or
open windows.
• Store paper flat on a shelf or pallet above floor level.
• Leave the paper wrapped and boxed until ready to be used.
• Re-wrap partly used packages of paper.
NOTE: Paper should not be stored in the paper trays.
Supported Paper Sizes and Types
This section lists the sizes and types of paper that can be used with the machine.
Supported Paper Sizes
The following table lists the paper sizes supported for each paper tray, duplex module
and the finisher.
NOTE: For the capacity of each tray, refer to the Specifications chapter.
Standard Sizes
NOTE: The standard sizes of paper that can be detected vary depending on the paper
size table specified by the Key Operator. For information on setting the paper size
table, refer to Paper Size Settings in the Setups chapter on page 234.
#
Paper
Size
Dimensions
(mm)
LEF/
SEF
Tray 1/
Tray 2, 3
(Two Tray
Module)
Tray 2, 3
(TTM)
Tray 5
(Bypass)
Duplex
Module
Office
Finisher
Integrated
Office
Finisher
A6 105.0 148.0 LEF X X X
A5 148.0 210.0 SEF O X O O X O
LEF X X X O
A4 210.0 297.0 SEF O X O O O
LEF O O O O O
A3 297.0 420.0 SEF O X O O O
Downloaded From ManualsPrinter.com Manuals

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English