Xerox WorkCentre 7132 User Guide

Fax Mode Settings
Xerox WorkCentre 7132 User Guide 271
TIFF Format
Specifies the type of the TIFF format to be used when TIFF is selected for saving
scanned data.
Image Transfer Screen
Specifies whether to display a confirmation message when scanning is finished. Select
from [Disabled], [Display Message Only], and [Display Message and Screen].
Fax Mode Settings
This section describes the features that allow you to change the default settings for the
fax mode. For more information, refer to the following.
Screen Defaults – page 271
Fax Defaults – page 272
Fax Control – page 273
File Destination/Output Destination – page 276
Reduce/Enlarge Presets – page 277
Original Size Defaults – page 277
Local Terminal Information – page 278
iFax Control – page 279
1. Select [Fax Mode Settings] on
the [System Settings] screen.
2. Select the required option.
3. Select [Close].
Screen Defaults
This feature allows you to define the initial settings for the fax feature screens.
1. Select [Screen Defaults] on the
[Fax Mode Settings] screen.
2. Change the required settings.
3. Select [Close].
Fax Screen Default
Specifies the fax default screen to display when you select the fax/Internet Fax feature.
Select from [Fax Recipients Programming Screen], [General Settings], and [Address
Book].
Downloaded From ManualsPrinter.com Manuals

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English