Common Settings
Xerox WorkCentre 7132 User Guide 233
Initialize Hard Disk
This feature allows you to initialize the hard disk on the machine. After selecting
[Initialize Hard Disk], select a partition, and then select [Start]. Then select [Yes] to
execute initialization. After the initialization finishes, select [Confirm].
NOTE: This process may take a while depending on the machine configuration.
Delete All Data
This feature allows you to delete all document data on the machine. Select [Delete All
Data], and then select [Start]. Then select [Yes] to execute deletion. After the deletion
finishes, you need to switch the machine off and then on.
NOTE: This process may take a few hours depending on the machine configuration.
Software Options
Specifies software options. For information on setting procedures and software codes,
refer to the instructions for the required software option package. Enter passwords for
the software options using the keyboard screen and select [Reboot].
Document Feeder Scanning Position
This feature allows you to adjust the scanning position of the document feeder precisely
in the range in 0.1mm (0.004 inch) increments. Select [Factory Settings] to restore the
default settings.
Other Settings
This feature allows you to configure various other settings common to the main features
such as copy, fax, and scan.
1. Select [Other Settings] on the
[Common Settings] screen.
2. Change the required settings.
Use the side tabs to switch
between screens.
3. Select [Close].
Offset Stacking (Center Output Tray )
Specifies the output paper stacking position for the Center Output Tray. When printing,
the machine can slightly offset the paper output positions for each set (copies) or job
(individually instructed print job). This allows you to identify the start of each set or job.
Offset Stacking (Finisher Tray)
Specifies the output paper stacking position for the Finisher Tray. When printing, the
machine can slightly offset paper output positions for each set (copies) or job
(individually instructed print job). This allows you to identify the start of each set or job.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
