15 Problem Solving
394 Xerox WorkCentre 7132 User Guide
Staple Jams in the Office Finisher(Optional)
The following describes how to clear staple jams when the Office Finisher is installed.
1. Make sure that the machine has
stopped, and then open the front
cover on the Office Finisher.
2. Hold the staple cartridge by its
lever as shown in the figure on
the right, and draw out the
staple cartridge to the right
towards you.
3. Lift up to remove the staple
cartridge.
4. After removing the staple
cartridge, check the inside of the
Office Finisher for any remaining
staples.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
