Xerox WorkCentre 7132 User Guide

Fault Codes
Xerox WorkCentre 7132 User Guide 403
Fault Codes
When a fault occurs, the touch screen displays a message on how to clear the fault.
Some faults indicate customer maintenance, while others require the attention of the
Key Operator and/or System Administrator. The following table represents some of the
fault codes and their corresponding corrective actions. These may appear in the Print
Queue or Faults List available in the Machine Status mode.
Code Description and Remedy
002-770 The job template could not be processed due to insufficient hard disk space.
Delete unnecessary data from the hard disk.
003-750 No document was saved for the double-sided Booklet Creation feature. Check
the setting of the double-sided Booklet Creation feature.
003-751 The specified document area is too small. Select a higher resolution or a larger
scan area.
003-754
003-755
An error occurred in the document scanner. Reset the document, and scan
again.
003-756 The fax document is completely white. Check that the original is not white, or
that the front and back sides have been reversed.
003-760 Incompatible features are selected in the document scan conditions. Check the
selected options.
003-761 The paper size in the tray selected by auto tray switching, differs from the paper
size in the tray selected at the tray selection. Either change the paper size for
the tray, or change the paper type priority setting.
003-763 An error occurred when reading the Gradation Adjustment Chart. Place the
chart properly on the document glass.
003-780 Compression of scanned data was unsuccessful. Lower the resolution or
reduction/enlargement ratio to reduce the data size, or send the document in
smaller segments.
003-795 The reduction/enlargement ratio exceeds the setting range when the scanned
document is enlarged/reduced to the specified paper size. Directly enter the
reduction/enlargement ratio, or change the paper size.
003-981 Stapling mixed size documents is available only for documents with the same
width. Cancel the staple feature or reset the documents with the same width.
005-210
005-275
005-280
005-283
005-284
005-285
005-286
An error occurred in the document feeder. Contact the Xerox Welcome Center.
Downloaded From ManualsPrinter.com Manuals

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English