Xerox WorkCentre 7132 User Guide

Network Settings
Xerox WorkCentre 7132 User Guide 249
PJL
Specifies whether to enable the PJL (Printer Job Language).
Auto Eject Time
Specifies the time-out period when print data is not sent to the machine sequentially. If
the specified time elapses, the remaining data inside the machine is automatically
printed out. You can enter a time within the range of 5-1,275 seconds in 5-second
increments.
Adobe Communication Protocol
Specifies the communication protocol format for Adobe Communication Protocol.
• Standard - Select this option when the communication protocol is in the ASCII
format.
• Binary - Select this option when the communication protocol is in the binary format.
Depending on the data, the print job may be completed faster than [Standard].
• TBCP - Select this option to switch the specific control codes when the
communication protocols involve both ASCII and binary formats.
LPD
Specifies whether to enable the LPD port and set the port number.
NetWare
Specifies whether to enable the NetWare port.
SMB
Specifies whether to enable the SMB port.
IPP
Specifies whether to enable the IPP port and set the port number.
EtherTalk
Specifies whether to enable the EtherTalk port.
Bonjour
Specifies whether to enable the Bonjour port.
Salutation
Specifies whether to enable the Salutation port.
Port 9100
Specifies whether to enable the Port 9100 port and set the port number.
Downloaded From ManualsPrinter.com Manuals

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English