4 Fax/Internet Fax
94 Xerox WorkCentre 7132 User Guide
DTMF Method - Examples
The DTMF method uses combinations of special characters to send documents. See
the following examples.
• Remote Mailbox - Sends a document to a mailbox on a remote machine.
• Polling - Retrieves a document stored in a mailbox on a remote machine.
/ Mask data (to
protect
confidential
information)
Select [/] before and after entering confidential information
to display as asterisks. This character must be preceded
with “!” to be effective.
\ Screen mask Masks the mailbox password on the screen with asterisks
(*). Select [
\] before and after entering a mailbox password.
: Pulse-to-tone
switch
Switches pulse dialing to tone dialing, for example when
using an automated message recording system that
requires tone signals.
’ Speed dial or
group code
Indicates a 3-digit speed dial or group code. Place this
character before and after the code.
< > Communication
line switch
Switches communication lines that include parameter data,
where the parameter data include characters “0” to “9” or
“,”. The parameter data must be placed between angle
brackets (“<” and “>”). If G3-3CH is installed, entering
either <1>, <2>, or <4> prior to specifying the fax
destination switches the communication lines.
= Dial tone
detection
Suspends dialing until a dial tone is detected.
S Password check
(for remote
machine
identification)
Use this character to verify that the correct number has
been entered. The machine checks if the password you
entered after “S” matches the fax number of the remote
machine. If the match is confirmed the machine sends the
document.
space Readability
improvement
Improves readability by inserting spaces in a telephone
number, for example “1 234 5678” instead of “12345678”.
! Start DTMF code
signaling
Pauses regular fax dialing, and starts the DTMF (dual tone
multi-frequency) method for sending documents to
mailboxes on the remote machines.
$ Wait for DTMF
confirmation
Wait for a DTMF confirmation signal from the remote
machine and proceed to the next step.
Telephone number of
remote machine
!*$ Mailbox number of
remote machine
##\ Mailbox password \##$
Character Function Description
Downloaded From ManualsPrinter.com Manuals