5-302 Agilent 4155C/4156C SCPI Command Reference, Edition 1
SCPI Commands
:SYSTem:BEEPer:STATe
:SYSTem:BEEPer:STATe
This command controls whether the beeper is enabled.
At *RST, this value is ON.
Syntax :SYSTem:BEEPer:STATe OFF | ON | 0 | 1
Parameter
Query response 0 | 1 <newline><^END>
Example OUTPUT @Hp4155;":SYST:BEEP:STAT ON"
OUTPUT @Hp4155;":SYST:BEEP:STAT?"
ENTER @Hp4155;A
:SYSTem:COMMunicate:GPIB:RDEVice:ADDRess
This command sets the GPIB bus address of hard copy.
This command does not affect the address of the peripheral device.
The 4155C/4156C sends hard copy data to the device which has specified GPIB bus
address.
At *RST, the value of this parameter is 1.
Syntax :SYSTem:COMMunicate:GPIB:RDEVice:ADDRess address | MINimum |
MAXimum
Parameter
Query response address <newline><^END>
address is NR1 response data.
Parameter Type Explanation
OFF or 0 boolean beeper is disabled
ON or 1 boolean beeper is enabled
Parameter Type Explanation
address numeric 0 to 30
To Next Page
Loading...
