Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-79
SCPI Commands
PAGE Subsystem
The PAGE subsystem commands are divided into several sections. Each command
sets the fields of the "fill in the blank" user interface pages.
The hierarchy of the PAGE subsystem command is similar to the user interface page
structure, except for the SCONtrol Subsystem.
The SCONtrol Subsystem controls the state of the 4155C/4156C, such as
measurement, stress forcing, standby, and idle.
The SYSTEM group page functions are not implemented in the PAGE subsystem.
These functions are controlled by other subsystems, such as MMEMory and
HCOPy.
The following table shows the relation between the upper level keywords of the
PAGE Subsystem and the user interface pages. Basically the first level keywords
correspond to the page group, and the second level keywords correspond to the page
name.
Command Hierarchy User Interface Page Name
:PAGE
:CHANnels
[:CDEFinition] CHANNELS: CHANNEL DEFINITION
:MATrix CHANNELS: E5250A PROPERTIES
:UFUNction CHANNELS: USER FUNCTION DEFINITION
:UVARiable CHANNELS: USER VARIABLE DEFINITION
:DISPlay
[:SETup] DISPLAY: DISPLAY SETUP
:ANALysis DISPLAY: ANALYSIS SETUP
To Next Page
Loading...
Need help?
General
