Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-117
SCPI Commands
:PAGE:DISPlay:ANALysis:LINE(1|2):TANGent:AFTer :STATe
var_name and expr are string response data, but do not contain double quote
characters at the beginning and end.
Example OUTPUT @Hp4155;":PAGE:DISP:ANAL:LINE1:TANG:AFT 'DGM','MA
X(DGM)'"
OUTPUT @Hp4155;":PAGE:DISP:ANAL:LINE1:TANG:AFT?"
ENTER @Hp4155;A$
:PAGE:DISPlay:ANALysis:LINE(1|2):TANGent:AFTer
:STATe
This command selects whether the start position of search is valid.
If TANG:AFTER var_name, expr is set, the STATe is automatically set to ON.
If LINE(1|2):MODE is not TANGent, this parameter is ignored.
At *RST, this value is OFF.
Syntax :PAGE:DISPlay:ANALysis:LINE(1|2):TANGent:AFTer:STATe OFF | ON | 0 | 1
Parameter
Query response 0 | 1 <newline><^END>
Example OUTPUT @Hp4155;":PAGE:DISP:ANAL:LINE1:TANG:AFT:STAT ON"
OUTPUT @Hp4155;":PAGE:DISP:ANAL:LINE1:TANG:AFT:STAT?"
ENTER @Hp4155;A
Parameter Type Explanation
OFF or 0 boolean search entire area for the point
ON or 1 boolean search for point only after the specified start position
To Next Page
Loading...
Need help?
General
