Agilent Technologies 4156C

Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-139
SCPI Commands
:PAGE:GLISt[:GRAPhics]:LINE:GRADient
:PAGE:GLISt[:GRAPhics]:LINE:GRADient
This command sets the gradient value of line.
If LINE:LSELect is NONE, this command is ignored.
At *RST, this value is undefined.
Syntax :PAGE:GLISt [ :GRAPhics] :LINE:GRADient gradient
Parameter
Query response gradient <newline><^END>
gradient is NR3 response data type.
Example OUTPUT @Hp4155;":PAGE:GLIS:LINE:GRAD 1.5"
OUTPUT @Hp4155;":PAGE:GLIS:LINE:GRAD?"
ENTER @Hp4155;A
:PAGE:GLISt[:GRAPhics]:LINE:LSELect
This command selects the line to operate on.
At *RST, this value is NONE.
Syntax :PAGE:GLISt [ :GRAPhics] :LINE:LSELect LINE1 | LINE2 | NONE |
line_number | MINimum | MAXimum
Parameter
Parameter Type Explanation
gradient numeric gradient value of line
Parameter Type Explanation
LINE1 character line 1 is selected
LINE2 character line 2 is selected
NONE character no lines are selected
line_number numeric 1 or 2