5-140 Agilent 4155C/4156C SCPI Command Reference, Edition 1
SCPI Commands
:PAGE:GLISt[:GRAPhics]:LINE:MODE
Query response line_number <newline><^END>
Example OUTPUT @Hp4155;":PAGE:GLIS:LINE:LSEL 1"
OUTPUT @Hp4155;":PAGE:GLIS:LINE:LSEL?"
ENTER @Hp4155;A
:PAGE:GLISt[:GRAPhics]:LINE:MODE
This command selects the line mode.
Although this value is not defined at *RST, if you select the line to operate on by
using :PAGE:GLISt[:GRAPhics]:LINE:LSELect, this value is set to NORM.
Syntax :PAGE:GLISt [ :GRAPhics] :LINE:MODE NORMal | GRADient | TANGent |
REGRession
Parameter
Query response NORM | GRAD | TANG | REGR <newline><^END>
Example OUTPUT @Hp4155;":PAGE:GLIS:LINE:MODE GRAD"
OUTPUT @Hp4155;":PAGE:GLIS:LINE:MODE?"
ENTER @Hp4155;A$
:PAGE:GLISt[:GRAPhics]:LINE:SCURsor
This command toggles which cursor you want to operate on.
This command does not have query form.
Syntax :PAGE:GLISt [ :GRAPhics] :LINE:SCURsor
Example OUTPUT @Hp4155;":PAGE:GLIS:LINE:SCUR"
Parameter Type Explanation
NORMal character normal mode
GRADient character gradient mode
TANGent character tangent mode
REGRession character regression mode
To Next Page
Loading...
