Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-173
SCPI Commands
:PAGE:MEASure:MSETup:ZCANcel[:STATe]
Query response 0 | 1 <newline><^END>
Example OUTPUT @Hp4155;":PAGE:MEAS:MSET:ZCAN:SMU1?"
ENTER @Hp4155;A
See also :PAGE:MEAS:MSET:ZCAN[:STATe]
:PAGE:MEASure:MSETup:ZCANcel[:STATe]
This command controls whether the ZERO OFFSET CANCEL mode is enabled.
At *RST, this value is OFF.
Syntax :PAGE:MEASure:MSETup:ZCANcel [ :STATe] OFF | ON | 0 | 1
Parameter
Query response 0 | 1 <newline><^END>
Example OUTPUT @Hp4155;":PAGE:MEAS:MSET:ZCAN ON"
OUTPUT @Hp4155;":PAGE:MEAS:MSET:ZCAN?"
ENTER @Hp4155;A
Parameter Type Explanation
0 boolean zero offset cancel is not enabled.
1 boolean zero offset cancel is enabled.
Parameter Type Explanation
OFF or 0 boolean zero offset cancel is not enabled for any units.
ON or 1 boolean zero offset cancel is enabled depending on the
settings of each unit.
To Next Page
Loading...
