Agilent Technologies 4156C Command Reference

5-214 Agilent 4155C/4156C SCPI Command Reference, Edition 1
SCPI Commands
:PAGE:MEASure:SAMPling:PERiod:AUTO
:PAGE:MEASure:SAMPling:PERiod:AUTO
This command sets the TOTAL SAMPLING TIME for sampling measurement.
This command is available only for LINear mode.
If you set :PAGE:MEAS:SAMP:PER total_samp_time, then AUTO OFF is set.
Syntax :PAGE:MEASure:SAMPling:PERiod:AUTO OFF | ON | 0 | 1
Parameter
Query response 0 | 1 <newline><^END>
Example OUTPUT @Hp4155;":PAGE:MEAS:SAMP:PER:AUTO ON"
OUTPUT @Hp4155;":PAGE:MEAS:SAMP:PER:AUTO?"
ENTER @Hp4155;A
:PAGE:MEASure:SAMPling:POINts
This command sets the NUMBER OF SAMPLES for sampling measurement.
Syntax :PAGE:MEASure:SAMPling:POINts no_of_samples | MINimum | MAXimum
Parameter
Query response no_of_samples <newline><^END>
no_of_samples is NR1 response data type.
Parameter Type Explanation
OFF or 0 boolean :PAGE:MEAS:SAMP:PER setting is effective.
ON or 1 boolean auto (disables total sampling time stop event, and
enables the number of samples stop event.)
Parameter Type Explanation
no_of_samples numeric 1 to 10001

Agilent Technologies 4156C Specifications

General

Brand	Agilent Technologies
Model	4156C
Category	Measuring Instruments
Language	English