Agilent Technologies 4156C Command Reference

5-240 Agilent 4155C/4156C SCPI Command Reference, Edition 1
SCPI Commands
:PAGE:MEASure[:SWEep]:VARD:RATio
:PAGE:MEASure[:SWEep]:VARD:RATio
This command sets the RATIO of VAR1'.
For each step of sweep, the output values of VAR1' are determined by the following
equation:
VAR1’ = VAR1 ´ RATio + OFFSet
You use this command only if there is an SMU or VSU whose function (FCTN) is
VA R 1 ' .
At *RST, this value is not defined.
Syntax :PAGE:MEASure [ :SWEep] :VARD:RATio ratio | MINimum | MAXimum
Parameter
Query response ratio <newline><^END>
ratio is NR3 response data type.
Example OUTPUT @Hp4155;":PAGE:MEAS:VARD:RATIO 0.1"
OUTPUT @Hp4155;":PAGE:MEAS:VARD:RATIO?"
ENTER @Hp4155;A
See also :PAGE:MEASure[:SWEep]:VARD:OFFSet
Parameter Type Explanation
ratio numeric ratio of VAR1'

Agilent Technologies 4156C Specifications

General

Brand	Agilent Technologies
Model	4156C
Category	Measuring Instruments
Language	English