5-52 Agilent 4155C/4156C SCPI Command Reference, Edition 1
SCPI Commands
:HCOPy:LINDex
:HCOPy:LINDex
This command specifies the range of measurement results to output by using index
numbers.
You use this command only if the current display page is GRAPH/LIST: LIST.
This command also changes the value of :MMEMory:STORe:SSHeet:LINDex.
At *RST, this value is set to (1,MAX).
This command does not comply with SCPI.
Syntax :HCOPy:LINDex first | MINimum | MAXimum, last | MINimum | MAXimum
Parameter
Query response first,last <newline><^END>
The data type of first and last are NR1 response data.
Example OUTPUT @Hp4155;":HCOP:LIND 1,MAX"
OUTPUT @Hp4155;":HCOP:LIND?"
ENTER @Hp4155;A,B
See also :MMEMory:STORe:SSHeet:LINDex
:HCOPy:OPAGe
This command sets the range of the setup data to be output.
At *RST, this value is set to CURRent.
Syntax :HCOPy:OPAGe CURRent | GROup | ALL
Parameter Type Explanation
first numeric first index number to output
last numeric last index number to output
To Next Page
Loading...
