Agilent Technologies 4156C Command Reference

Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-221
SCPI Commands
:PAGE:MEASure[:SWEep]:CONStant:VSU<n>[:SOURce]
:PAGE:MEASure[:SWEep]:CONStant:VSU<n>[:SOU
Rce]
This command sets the constant SOURCE value of VSU<n> for the sweep
measurement.
<n> is required to specify VSU number. Valid VSU numbers are VSU1 through
VSU2.
You use this command only if the function of the specified VSU is CONStant.
At *RST, this value is 0V.
Syntax :PAGE:MEASure [ :SWEep] :CONStant:VSU<n>[ :SOURce] source | MINimum |
MAXimum
Parameter
Query response source <newline><^END>
source is NR3 response data type.
Example OUTPUT @Hp4155;":PAGE:MEAS:CONS:VSU1 10"
OUTPUT @Hp4155;":PAGE:MEAS:CONS:VSU1 MAX"
OUTPUT @Hp4155;":PAGE:MEAS:CONS:VSU1?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:MEAS:CONS:VSU1? MAX"
ENTER @Hp4155;A
Parameter Type Explanation
source numeric -20 to 20 V

Agilent Technologies 4156C Specifications

General

Brand	Agilent Technologies
Model	4156C
Category	Measuring Instruments
Language	English