1Getting Started
44 InfiniiVision 7000B Series Oscilloscopes User’s Guide
Rear Panel Connector Descriptions
1. External Trigger Input See “External Trigger Input” on page 109 for an
explanation of this feature.
2. Trigger Output See “Trigger Types” on page 112.
3. 10 MHz Reference Connector See “To set the reference signal mode” on
page 388.
4. Calibration Protect Switch See “To perform user calibration” on page 397.
5. Digital Input Connector Connect the digital probe cable to this connector
(MSO models only).
6. XGA Video Output A standard XGA video output connector is provided
on the rear panel.
You can connect an external monitor to provide a larger display or to
provide a display at a viewing position away from the oscilloscope.
The oscilloscope’s built- in display remains on even when an external
display is connected. The video output connector is always active.
For optimal video quality and performance, we recommend you use a
shielded video cable with ferrite cores.
7. USB Host Port This port functions identically to the USB host port on
the front panel. USB Host Port is used for saving data from the
oscilloscope and loading software updates. See also page 37.
8. USB Device Port This port is for connecting the oscilloscope to a host
PC. You can issue remote commands from a host PC to the oscilloscope
via the USB device port. See “Remote Programming with Agilent IO
Libraries” on page 249.
9. LAN Port You can communicate with the oscilloscope and use the
Remote Front Panel feature using the LAN port. See “Web Interface” on
page 239 and “Accessing the Web Interface” on page 244.
To Next Page
Loading...
Need help?
General
