Agilent Technologies 7000B Series - To Clear the Display; To Adjust the Grid Brightness

3 Displaying Waveforms
86 InfiniiVision 7000B Series Oscilloscopes User’s Guide
3 Press  Persist to turn on infinite persistence. The display will begin
accumulating multiple acquisitions.
4 Press the Clear  Persist softkey to erase previous acquisitions. The
oscilloscope will start to accumulate acquisitions again.
5 To return the oscilloscope to the normal display mode, turn off infinite
persistence; then, press the Clear  Persist softkey.
See also “Glitch or Narrow Pulse Capture” on page 119.
To clear the display
1 Press [Clear Display] (or press [Display] > Clear Display).
To adjust the grid brightness
To adjust the display grid (graticule) brightness:
1 Press [Display].
2 Press Grid; then, turn the Entry knob to change the intensity of the
displayed grid.
The intensity level is shown in the Grid softkey and is adjustable from 0
to 100%.
Each major vertical division in the grid corresponds to the vertical
sensitivity shown in the status line at the top of the display.
Each major horizontal division in the grid corresponds to the sweep
speed time shown in the status line at the top of the display.
NOTE
Accumulating multiple acquisitions
Turning off infinite persistence does not clear the display. This allows you to accumulate
multiple acquisitions, stop acquisitions, and then compare future acquisitions to the stored
waveforms. The display is cleared if you press the Clear Display softkey or if you press the
[AutoScale] key.