Saving, Recalling, and Printing 6
InfiniiVision 7000B Series Oscilloscopes User’s Guide 217
3 Press the Recall: softkey in the Recall Menu and choose Setup, Trace, or
Trace and Setup.
4 Press the second softkey from the left and navigate to the oscilloscope’s
internal memory location or the USB mass storage device that holds the
saved trace and/or setup. See “File Explorer” (below) for more
information.
5 Press the Press to Recall softkey.
File Explorer
The File Explorer lets you navigate the file system. Using the File Explorer
you can save, recall, load, and delete files.
File system The user- accessible file system consists of ten internal
memory locations, plus external USB mass storage devices you connect to
the USB device ports on the oscilloscope.
Internal memory The ten internal nonvolatile memory locations are located
on the oscilloscope at C:\setups and are named intern_0 through intern_9.
You can save waveform trace and oscilloscope setup in each of the ten
internal memory locations, but you cannot save display image files or
waveform data files in the oscilloscope’s internal memory. The latter must
be stored on USB mass storage devices.
USB mass storage devices Most USB mass storage devices are compatible
with the oscilloscope. However, certain devices may be incompatible, and
may not be able to be read or written to.
When the USB mass storage device is connected to the oscilloscope’s front
or rear USB host port, a small four- color circle icon may be displayed
briefly as the USB device is read.
You do not need to “eject” the USB mass storage device before removing
it. Simply ensure that any file operation you’ve initiated is done, and
remove the USB drive from the oscilloscope’s host port.
Do not connect USB devices that identify themselves as hardware type
“CD” because these devices are not compatible with the InfiniiVision
7000B Series oscilloscopes.
To Next Page
Loading...
Need help?
General
