Agilent Technologies 7000B Series User Manual

17 Digital Channels
364 InfiniiVision 7000B Series Oscilloscopes User’s Guide
To display digital channels using AutoScale
When signals are connected to the digital channels, AutoScale quickly
configures and displays the digital channels.
• To configure the instrument quickly, press the [AutoScale] key.
Any digital channel with an active signal will be displayed. Any digital
channels without active signals will be turned off.
• To undo the effects of AutoScale, press the Undo AutoScale softkey before
pressing any other key.
This is useful if you have unintentionally pressed the [AutoScale] key or
do not like the settings AutoScale has selected. This will return the
oscilloscope to its previous settings.
For information about how AutoScale works, see page 33.
To set the instrument to the factory- default configuration, press the
[Default Setup] key.
Example
Install probe clips on channels 0 and 1 of the digital probe cable. Connect
the probes for digital channels 0 and 1 to the Probe Comp output on the
front panel of the instrument. Be sure to connect the ground lead to the

Agilent Technologies 7000B Series Specifications

General

Brand	Agilent Technologies
Model	7000B Series
Category	Test Equipment
Language	English