Agilent Technologies 7000B Series - Searching for I2 S Data in the Lister

12 I
2
S Triggering and Serial Decode
312 InfiniiVision 7000B Series Oscilloscopes User’s Guide
Searching for I
2
S Data in the Lister
The oscilloscope’s search capability lets you search for (and mark) certain
types of I
2
S data in the Lister. You can use the [Navigate] key and controls
to navigate through the marked rows.
1 With I
2
S selected as the serial decode mode, press [Search].
2 In the Search Menu, press Search for; then, select from these options:
• = (Equal) — finds the specified audio channel’s data word when it
equals the specified word.
• != (Not Equal) — finds any word other than the specified word.
• < (Less than) — finds when the channel’s data word is less than the
specified value.
• > (Greater than) — finds when the channel’s data word is greater than
the specified value.
• >< (In Range) — enter upper and lower values to specify the range to
find.
• <> (Out of Range) — enter upper and lower values to specify range not
to find.
• Errors — finds all errors.
For more information on searching data, see “Searching Lister Data” on
page 259.
For more information on using the [Navigate] key and controls, see “To
navigate the time base” on page 74.