8Web Interface
242 InfiniiVision 7000B Series Oscilloscopes User’s Guide
To connect to the network using Manual mode
1 Get the oscilloscope’s network parameters (hostname, domain, IP
address, subnet mask, gateway IP, DNS IP, etc.) from your network
administrator.
2 Connect the oscilloscope to the local area network (LAN) by inserting
the LAN cable into the “LAN” port on the rear panel of the
oscilloscope.
3 On the oscilloscope, ensure the controller interface is enabled:
a Press [Utility] > I/O > Control.
b Ensure that LAN is selected. If not, use the Entry knob to point to
“LAN” and then push the Entry knob.
4 Configure the oscilloscope’s LAN interface:
a Press the LAN Settings softkey.
b Press the Config softkey to deselect DHCP and AutoIP.
c Press the Addresses softkey.
d Use the Modify softkey (and the other softkeys and the Entry knob)
to enter the IP Address, Subnet Mask, Gateway IP, and DNS IP
values. When you are done, go back up in the menu hierarchy.
e Press the Domain softkey. Use the Modify softkey (and the other
softkeys and the Entry knob) to enter the Host name and the
Domain name. When you are done, go back up in the menu
hierarchy.
f Press the Apply softkey.
Stand-alone (Point-to-Point) Connection to a PC
The following procedure describes how to establish a point-to- point (stand
alone) connection to the oscilloscope. This is useful if you want to control
the oscilloscope using a laptop computer or a stand- alone computer.
1 Connect your PC to the oscilloscope using a cross- over LAN cable such
as Agilent part number 5061- 0701, available on the web at
www.parts.agilent.com.
2 Turn on the oscilloscope power. Wait until the LAN connection is
configured:
To Next Page
Loading...
Need help?
General
