1Getting Started
30 InfiniiVision 7000B Series Oscilloscopes User’s Guide
To power-on the oscilloscope
1 Connect the power cord to the rear of the oscilloscope, then to a
suitable AC voltage source. Route the power cord so the oscilloscope’s
feet and legs do not pinch the cord.
The oscilloscope automatically adjusts for input line voltages in the
range 100 to 240 VAC. The line cord provided is matched to the country
of origin.
2 Press the power switch.
The power switch is located on the lower left corner of the front panel.
The oscilloscope will perform a self- test and will be operational in a
few seconds.
Always use a grounded power cord. Do not defeat the power cord ground.
To Next Page
Loading...
