6 Saving, Recalling, and Printing
216 InfiniiVision 7000B Series Oscilloscopes User’s Guide
4 Choose a file format using the Format softkey. For file format
information see “Display Image and Waveform Data File Formats” on
page 210.
5 Press the Press to Save softkey.
To save a waveform and/or setup to the oscilloscope’s
internal memory
1 Press the [Save/Recall] key.
2 Press the Save softkey.
3 Press the Format softkey and choose Trace and Setup.
4 Press the Save to softkey. Then rotate the Entry knob to navigate to the
“C:\setups” directory, then choose one of the files to overwrite
(intern_0 through intern_9). You can push the Entry knob to make your
directory and file selections.
5 Press the Press to Save softkey or select the file using the Entry knob and
then press the Entry knob.
To recall waveform trace and/or oscilloscope setup
A recalled trace is typically used for a quick comparison of measurement
results. For example, you might save a trace of a waveform to use as a
reference, then make a similar measurement on a test system and then
recall the saved trace to observe any differences.
1 Press the [Save/Recall] key.
2 Press the Recall softkey. The Recall Menu will be displayed.
When saving display image files, the oscilloscope will save an image using the last menu
you visited before pressing the [Print] key. Therefore, if you have measurements
(Amplitude, Frequency, etc.) showing on the display before you select Save, the
measurements will be shown in the display image file.
To save an image of the display showing the Save/Recall Menu at the bottom, press the
[Save/Recall] key twice, then press the Press to Save softkey.
To Next Page
Loading...
Need help?
General
