18 Oscilloscope Utility Settings
386 InfiniiVision 7000B Series Oscilloscopes User’s Guide
To preserve the acquisition mode during autoscale
The acquisition mode is normally switched to Normal when [AutoScale] is
performed. However, you can tell it to leave the acquisition mode
unchanged.
1 Press [Utility] > Options > Preferences > AutoScale.
2 In the AutoScale Preferences Menu, press Acq Mode; then select:
• Normal — to make the oscilloscope switch to Normal acquisition mode
whenever the [AutoScale] key is pressed. This is the default mode.
• Preserve — to make the oscilloscope remain in the acquisition mode
you have chosen when the [AutoScale] key is pressed.
To disable/enable transparent backgrounds
There is a preference setting for whether measurements, statistics, and
other text displays have transparent or solid backgrounds.
1 Press [Utility] > Options > Preferences > More.
2 Press Transparent to toggle between transparent and solid text display
backgrounds.
To load the default label library
See “To reset the label library to the factory default” on page 93.
To specify the measurement window for Zoom mode
When the zoomed time base is displayed, you can specify whether the
upper, Main window or the lower, Zoom window is used as the
measurement window.
1 Press [Utility] > Options > Preferences > More.
2 Press Window to select from these measurement window options:
• Auto Select – The measurement is attempted in the lower, Zoom
window; if it cannot be made there, the upper, Main window is used.
To Next Page
Loading...
Need help?
General
