17 Digital Channels
360 InfiniiVision 7000B Series Oscilloscopes User’s Guide
To connect the digital probes to the device under test
The digital channels are enabled on MSO7000B Series models and
DSO7000B Series models which have the MSO upgrade license installed.
1 If necessary, turn off the power supply to the device under test.
Turning off power to the device under test would only prevent damage
that might occur if you accidentally short two lines together while
connecting probes. You can leave the oscilloscope powered on because
no voltage appears at the probes.
2 Connect the digital probe cable to the D15 - D0 connector on the rear
panel of the mixed- signal oscilloscope. The digital probe cable is
indexed so you can connect it only one way. You do not need to
power-off the oscilloscope.
3 Route the cable under the oscilloscope and bring it out in front.
Probe cable for digital channels
Use only the Agilent part number 54620-68701 digital probe kit supplied with the
mixed-signal oscilloscope.
To Next Page
Loading...
Need help?
General
