Agilent Technologies 7000B Series - Figure 40 User Calibration Cable for 2-Channel Oscilloscope

Oscilloscope Utility Settings 18
InfiniiVision 7000B Series Oscilloscopes User’s Guide 399
For a 2- channel oscilloscope, connect a BNC tee to the equal length
cables. Then connect a BNC(f)- to- BNC(f) (also called a barrel connector)
to the tee as shown below.
Figure 40 User Calibration cable for 2-channel oscilloscope
Longer cable
to TRIG OUT
To Channel 1
To Channel 2