6 Saving, Recalling, and Printing
218 InfiniiVision 7000B Series Oscilloscopes User’s Guide
If two USB mass storage devices are connected to the oscilloscope, the
first one is designated “USB0” and the second one is designated “USB5,”
not “USB1.” This numbering method is normal; it is inherent in the USB
driver.
A file that has been deleted from the USB mass storage device cannot be
recovered by the oscilloscope.
System software System software files can be loaded into the oscilloscope.
These software updatescan be downloaded from:
• www.agilent.com/find/7000sw
See “Software and Firmware Updates” on page 410 for more information.
To use the file explorer
Files can be loaded and deleted using the file explorer.
You can create directories on a USB mass storage device using your PC or
other instrument. You can navigate to any directory on the USB device by
rotating and pushing the Entry knob.
1 Connect a USB mass storage device with the files to be loaded or
deleted to the USB port on the front or the rear of the oscilloscope. A
small four- color circle icon may be displayed as the USB device is read.
2 Press [Utility] > File Explorer.
3 Turn and push the Entry knob to select the desired file on the USB
mass storage device. This softkey will be labeled Press to go when
pointing at a directory that can be selected, Location when pointing to a
directory that is currently selected, and Selected when pointing to a file
Regarding USB Ports:
The USB port on the front panel, and the USB port on the rear panel labeled “HOST” are
USB Series A receptacles. These are the receptacles to which you can connect USB mass
storage devices and printers.
The square receptacle on the rear panel labeled “DEVICE” is provided for controlling the
oscilloscope over USB. See the Programmer’s Guide for more information. To access the
Programmer’s Guide online, direct your web browser to:
• www.agilent.com/find/7000manual
To Next Page
Loading...
Need help?
General
