123
If you start playback before the loop start time, SONAR will play until the loop end
time is reached, then jump back to the loop start time.
Note: If you stop playback while looping is enabled, the Now time jumps to the
Now time marker. If you disable the On Stop Rewind to Now Marker option in the
General tab of the Global Options dialog, the Now time stays wherever you
stopped playback.
The Rewind command operates slightly differently when looping is in effect. The
first time you rewind, the Now time is set to the start of the loop. If the Now time
is already at the start of the loop, Rewind takes you to the beginning of the project.
From then on, Rewind switches back and forth between the loop start time and the
start of measure 1.
To Set Up a Playback Loop
1. Set the loop start and end times in one of the following ways:
• Drag the mouse between two points in the Time Ruler of the Track view,
Staff, or Piano Roll view to select a range of times, then click in the
Loop/Auto Shuttle toolbar to copy the selection time to the loop time.
• Click between two markers in the Track, Staff, or Piano Roll view to select
a range of times, then click in the Loop/Auto Shuttle toolbar to copy
the selection time to the loop time.
• Type the loop start and end times directly into the toolbar.
• Select a range of times, then right-click in the Time Ruler and choose Set
Loop Points (this method makes the second option unnecessary).
Looping is automatically turned on when you use the Set Loop to Selection
command.
To Change the Loop Settings
1. Click , or choose Transport-Loop and Auto Shuttle to display the Loop/
Auto Shuttle dialog box.
2. Check the options you want to use.
3. Click OK.
To Cancel a Playback Loop
• Click on the toolbar to disable looping.
To Next Page
Loading...