213
Using the Navigator View
The Navigator view displays a large part of your project so you can see an overview
of your song. The Navigator view is a floating version of the Navigator pane found
at the top of the Track view.
Track Rectangle
The Track Rectangle appears as a green rectangle within the Navigator view. The
Track Rectangle indicates the section of your project which appears in the Clips
pane of the Track view. You can move the Track Rectangle or change its size.
To Move the Track Rectangle
1. Position your cursor inside the Track Rectangle until the icon changes to look
like this: .
2. Click and drag the rectangle where you want and release.
To Change the Size of the Track Rectangle
1. Click one of the nodes on the rectangle border.
2. Drag to change the rectangle size.
To Change the Now Time in the Navigator view
1. Hold down the Ctrl key.
2. Click where you want the Now Time to be.
Double-clicking Clips
By default, double-clicking a MIDI clip in the Clips pane opens a Piano Roll view
for that track, and double-clicking an Audio clip opens the Loop Construction view
for that track. You can set the type of view opened when a clip is double-clicked.
For example, you may want to open MIDI tracks in a Staff view rather than in a
Piano Roll view.
To Set the View Opened by Double-clicking
1. Right-click in the Clips pane and choose View Options.
2. Select the types of view opened by double-clicking MIDI and audio clips.
3. Click OK.
To Next Page
Loading...