CAKEWALK SONAR - Starting SONAR

27
To Install SONAR
1. Start your computer.
2. Close any open programs you have running.
3. Place the SONAR CD-ROM in your CD-ROM drive.
If you have autorun enabled, the SONAR AutoRun menu opens automatically,
showing you a dialog box with several buttons. If autorun is not enabled, you
can open the SONAR AutoRun menu by selecting Start-Run and entering
d:\AutoRun.exe (where d:\ is your CD-ROM drive).
4. Click the Install SONAR button.
5. Follow the installation instructions on the screen.
You can also install SONAR by choosing Start-Run and running the application
named
SETUP.EXE from the CD.
Uninstalling SONAR 4
When you installed SONAR, the setup program placed an Uninstall icon in the
Start menu. To uninstall SONAR, click the Start button and choose Programs-
Cakewalk-SONAR 4 (Studio Edition or Producer Edition)-Uninstall
SONAR 4 (Studio Edition or Producer Edition).
Starting SONAR
There are many different ways to start SONAR. Here are a few:
• Click on the SONAR icon on your desktop.
• Click on the Start button, and choose Programs-Cakewalk-SONAR 4
(Studio Edition or Producer Edition)-SONAR 4 (Studio Edition or
Producer Edition).
• Click the Start button, point to Documents, and choose a SONAR project from
the menu.
• Double-click the SONAR program or any SONAR document from the Windows
Explorer or the Find menu.
Note:
If you exit Setup without completing the installation, choose Start-Run,
type D:\AutoRun.exe (where D:\ is your CD-ROM drive), and click OK.
This will reopen the AutoRun window, and you can click Install SONAR
to start installation again.