604
Synchronization” on page 604. If you need to send MIDI Time Code (MTC),
SONAR will send this data regardless of the clock setting.
To Use the Internal Clock Source
1. Click on the Sync toolbar.
OR
1. Choose Options-Project, and click the Clock tab.
2. Check the Internal box.
3. Click OK.
To Use the Audio Clock Source
1. Click on the Sync toolbar.
OR
Choose Options-Project, and click the Clock tab.
2. Check the Audio box.
3. Click OK.
MIDI Synchronization
MIDI Synchronization, or MIDI Sync, is usually used to synchronize SONAR with
drum machines, stand-alone MIDI hardware sequencers, and sequencers built into
MIDI keyboards. SONAR can slave to MIDI Sync, and can send MIDI Sync on
multiple output ports.
When MIDI devices are synched, the master device sends messages to all other
devices to start and stop playback and to keep all the devices in sync. To change
the tempo of a project, you adjust the tempo on the master device. The playback
tempo on all slave devices is then set automatically.
To Next Page
Loading...