274
Event Inspector Toolbar
The Event Inspector toolbar is available from the View menu by selecting View-
Toolbars and checking Event Inspector in the Toolbars dialog. The Event
Inspector has the following:
•Time
•Pitch
• Velocity
•Duration
• Channel
To Display a Note’s Properties in the Event Inspector Toolbar
• Select a note.
If you select multiple notes, the Event Inspector toolbar displays the note
value if all selected note values are the same. If the note values are different,
the Event Inspector does not display anything.
To Change a Note’s Properties Using the Event Inspector
Toolbar
1. Select a note.
2. In the appropriate Event Inspector toolbar field, change the value. See the
table below for a description of valid value entries for each field in the Event
Inspector toolbar.
Event
Inspector
Field…
Valid Values…
Time Any valid M:B:T time value. Separate values with a colon or a
space. For example, measure 2, Beat 3, Tick 720 would be
written as 2:3:720.
Pitch Note names (C0 through G10) and note numbers (0 through 127)
are valid in this field. Also, you can use a modifier to raise or
lower the value by a number of half-steps. To raise the pitch by 2
half-steps, type +2 and press enter. To lower the pitch by 2 half-
steps, type -2 and press enter.
Velocity A velocity value or modifier value are valid in this field. Valid
velocity values are 0 through 127. Valid modifier values are +/- 0
through 127.
Duration A PPQ value.
Channel 1 through 16.
To Next Page
Loading...