CAKEWALK SONAR - Controlling Individual Pads-Volume, Pan, Mute, Solo, Sync; Looping, and Content

670
Controlling Individual Pads—Volume, Pan, Mute,
Solo, Sync, Looping, and Content
Each Pad has the following controls:
• Volume knob—turn to adjust.
• Pan knob—turn to adjust.
• Folder icon—click this to import a loop to an individual Pad.
• Mute button—click this to mute or unmute the loop that’s assigned to an
individual Pad.
• Solo button—click this to solo or un-solo the loop that’s assigned to an
individual Pad.
• Sync button—click this to synchronize (or unsynchronize) the Pad’s loop to
SONAR‘s pitch and tempo.
• Loop button—click this to cause or prevent the Pad’s loop from repeating
indefinitely between its track length markers that are in the Pad Editor.
To Export a Sound Bank
1. Click the Export Sound Bank button in the Cyclone toolbar.
The Save As dialog appears.
2. Navigate to the directory where you want to save the Sound Bank.
3. Enter a name for the Sound Bank.
4. Click OK.
Cyclone DXi saves your Sound Bank. All wave files assigned to pads are saved. You
can choose that Sound Bank in any Cyclone project SONAR automatically saves
your current Cyclone settings, so you do not need to save a Sound Bank unless you
want to use these settings in a different project.
To Import a Sound Bank
1. Click the Import Sound Bank button on the Cyclone toolbar.
The Open dialog appears.
2. Navigate to the directory where you saved your Sound Bank, select it and click
OK.
Cyclone DXi loads the loops and associated settings that make up the Sound Bank
you loaded.
To Clear the Contents of a Project
• Click the Trash icon in the Cyclone DXi toolbar.
Cyclone DXi deletes all loops from your project.