393
Adding Flanging
The Cakewalk-FxFlange command mixes the original signal with a slightly
delayed version of the signal, so that the two are out of phase. This creates a
spacey, ethereal sound.
The parameters used to specify the chorus effect are as follows:
To Apply Flanging to Audio Data
1. Select the audio data to be affected. Select a stereo pair for stereo flanging.
2. Choose Audio Effects-Cakewalk-FxFlange from the Process menu or from
the popup menu to open the Cakewalk FxFlange dialog box.
3. Set the parameters in the dialog, as described in the table above.
4. Click OK.
SONAR applies the specified flanging effect to the selected data.
Parameter/Option... Meaning...
Delay(ms)—factor The delay time for
Feedback—factor The amount of output signal that is fed back through
the flanger.
Pan—factor Left/Right pan. 0 is center. -1 is hard left. 1 is hard
right.
Mod. Freq.—factor The speed at which the pitch modulates
Voice 1-2 Two separate flangers. Bypass a voice by clicking the
on button above the voice’s selection button.
Global Controls both voices.
Mix Level The Wet/Dry mix of the output. If set all the way to the
left, the chorus has no effect on output. If set all the
way to the right eliminates all dry signal.
Output Level Plug-ins output volume.
Bypass The plug-ins bypass button.
To Next Page
Loading...