207
To Insert a Blank Track
1. Right-click in the Track pane at the place where you want to insert a track,
and select Insert Audio Track to add an audio track or Insert MIDI Track
to add a MIDI track.
OR
1. Press Insert to add a track of the same type (audio or MIDI) as the current
track.
SONAR shifts the current track and all tracks below it down by one, and inserts a
blank, new track at the location of the highlight.
Configuring the Display of Tracks in the Track View
There are several commands in SONAR that allow you to configure the
appearance of your tracks in the track view. You can use these commands to zoom
in or out, show or hide any combination of tracks, and revert back to previous
display settings. The following table lists each of these commands and provides an
explanation of each:
Command… Description… Shortcut…
Show and Fit
Selection
This command hides all tracks which are not
selected. The remaining tracks are adjusted in size
vertically and horizontally to fit in the Track view,
without scrolling if possible. All track selections are
lost after this command is executed.
Shift+S
Fit Tracks to Window All currently displayed tracks are adjusted in size
vertically to fit in the Track view, without scrolling if
possible.
F
Fit Project to Window This command resizes all tracks both vertically and
horizontally to fit in the Tracks view.
Shift+F
Show Only Selected
Tracks
This command hides all tracks which are not
selected. The remaining tracks are adjusted in size
vertically.
H
Hide Selected Tracks Hides all selected tracks. Shift+H
Show All Tracks Shows all tracks in your project, including these
hidden using the Track Manager.
A
Track Manager Opens the Track manager dialog. For more
information about the Track Manager dialog, see
Track Manager dialog.
M
Undo View Change This command restores the view to its previous
state. There are up to 16 levels of undo.
U
Redo View Change This command restores the view to the state prior
to the Undo View Change command.
Shift+U
To Next Page
Loading...