389
Adding Parametric Equalization
The Cakewalk-FxEQ command lets you apply a complex filter to your audio data.
The complex filter is a combination of up to eight simple filters or bands, each
defined individually.
Parameters for each filter are described in the following table:
Parameter/Option... Meaning...
Voice The voice field lists the band which the other
parameters are affecting.
Center Frequency—coarse The center frequency of the current band (the band
listed in the Voice field). The range is from 20 Hz to
20,000 Hz.
Center Frequency—fine A fine tuning of the center frequency.
Bandwidth (Q)—coarse The bandwidth of the selected voice.
Bandwidth (Q)—fine A fine tuning of the bandwidth of the selected voice.
Active Channel L + R When selected the EQ affects both the left and right
channels.
Active Channel L When selected the EQ affects the left channel only.
Active Channel R When selected the EQ affects the right channel only.
Bypass The plug-in is bypassed in the chain.
Band (1-8) Each band can be set to a different frequency and
bandwidth or bypassed by clicking its bypass button
immediately above the band’s selection button.
Lo Shelf A low frequency gain or cut. Lo Shelf can be set from
between 20 and 200 Hz
Hi Shelf A high frequency gain or cut. Hi Shelf can be set as low
as 4000 Hz
Trim The trim setting for the plug-in.
To Next Page
Loading...