434
Stereo Buses
Buses are useful for mixing together different audio tracks (in stereo) and applying
effects to the mix. You can mix the tracks at different volume levels by adjusting
each track’s bus send level. Buses output to either other buses or to a main out.
You control the bus as follows:
To do this... Do this...
Send audio data from an audio track
to the bus
In an audio track, press the Bus Send Enable button
corresponding to the bus, or choose the bus as an
output for the track
Set the level of the audio data sent to
the bus
In an audio track, set the Bus Send Level
corresponding to the bus, or volume fader if the
output is to the bus
Set the pan of the audio data sent to
the bus
Adjust the Bus Send Pan knob
Set the input level to the bus Adjust the Input gain on the bus itself
Set the input panning to the bus Adjust the Input pan on the bus itself
Add a real-time audio effect to the bus Right-click in the FX patch point and select an effect
from the list (for more information, see “Using Real-
Time Effects” on page 444)
Remove an effect Select the effect and press Delete, or right-click and
choose Delete
Set the output level Adjust the Output volume
Set the output panning Adjust the Pan setting
Select the output Click the Output button and choose one from the list
To Next Page
Loading...