357
Basic Audio Editing
The Track view lets you perform basic editing tasks such as cut, copy, paste, delete,
drag-and-drop, split, and bounce. You can drag fade-ins and fade-outs onto a clip
using your mouse or you can set complex envelopes on both clips and tracks. You
can use envelopes to change settings for gain (volume), pan, mute, bus send level
and bus send pan. The Scrub tool lets you audition portions of audio by dragging
the mouse.
Use the Select tool to make selections.
Here is a summary of the ways in which you can select audio clips:
To do this... Do this...
Select a single clip Click the clip
Select several clips at once Drag a rectangle around them
Select part of an clip Press Alt and drag over a portion of the clips
Add clips to the selection Press Shift and either click the clips or drag a
rectangle around the clips
Add or remove clips from the selection Press Ctrl and either click the clips or drag a
rectangle around the clips
Add or remove clips in a track from the
selection
Click the track number
Select clips in a time range Drag in the Time Ruler
Select clips between two markers Click between the markers
Remove all selections Click in an empty area outside of any clip
To Next Page
Loading...