265
Editing Slices
Each slice (space between the slicing markers) can be adjusted in the Loop
Construction view. You can adjust the following slice attributes:
•Gain
•Pan
•Pitch
To Preview a Groove Clip Slice
1. Double-click on a clip to open the Loop Construction view.
2. Click the Enable Slice Auto-preview button.
3. Click a slice to hear it.
To Adjust a Groove Clip Slice Gain
1. In the Loop Construction view, select the slice on which you want to adjust the
gain.
2. In the Slice Gain field, click the plus or minus buttons to change the gain
value.
Or
Click between the plus and minus keys until the cursor becomes a double
arrow and drag up to increase the value or down to decrease the value.
To Adjust a Groove Clip Slice Pan
1. In the Loop Construction view, select the slice on which you want to adjust the
pan.
2. In the Slice Pan field, click the plus or minus buttons to change the pan value.
Negative is Left pan and positive is right pan.
To Adjust a Groove Clip Slice Pitch (Half Steps)
1. In the Loop Construction view, select the slice on which you want to adjust the
pitch.
2. In the first Slice Pitch field, click the plus or minus buttons to change the pitch
value.
To Adjust a Groove Clip Slice Pitch (Cents)
1. In the Loop Construction view, select the slice on which you want to adjust the
pitch.
2. In the second Slice Pitch field, click the plus or minus buttons to change the
pitch value.
To Adjust Slice Gain, Pan and Pitch Using Slice Envelopes
You can change an envelope’s gain, pan and/or pitch settings by dragging the
envelope up or down in that slice.
To Next Page
Loading...