236
Note: if the clip you’re muting or unmuting with this method already has one or
more muted time ranges, these time ranges remain muted while you Alt-click the
clip, so you don’t lose any precise mute edits you’ve performed. To completely
unmute the clip in the picture below, first Alt-click the clip to remove the Mute
icon, and then drag through the upper half of the clip in the muted area(s).
Clip Muting with the Alternate Style
When you choose Mute Entire Clips under Click+Drag Behavior in the Mute
tool dropdown menu, you can use the following procedures to mute all or parts of
clips. This is the alternate style.
To Enable or Disable the Mute Tool
• Click the Mute tool or press K on your keyboard. The Mute tool turns blue
when it is enabled.
To Mute or Unumute an Entire Clip Using Alternate Style
1. Make sure that Mute Entire Clips under Click+Drag Behavior in the Mute
tool dropdown menu has a check mark.
2. Using the Mute tool, click anywhere in the clip.
SONAR displays the Mute icon in the upper left corner of a muted clip.
Note: if the clip you’re muting or unmuting with this method already has one or
more muted time ranges, these time ranges remain muted while you Alt-click the
clip, so you don’t lose any precise mute edits you’ve performed.
To Mute a Time Range Using Alternate Style
1. Make sure that Mute Entire Clips under Click+Drag Behavior in the Mute
tool dropdown menu has a check mark.
2. If you want to mute a precise amount of time, enable the Snap to Grid button
and set its menu to an appropriate value.
3. Using the Mute tool, Alt-drag inside the lower half of a clip.
SONAR mutes the area you dragged through and displays the muted waveform or
MIDI data as a dotted line.
To Next Page
Loading...