CAKEWALK SONAR - Working in the Drum Map Manager

338
Settings
The Settings section is where you map the following for each In Note (source):
• In Note—The source MIDI note value.
• Out Note—The MIDI note value that plays on the destination sound source.
• Name—The user-defined name for the row.
• Chn—The channel on which the note is transmitted.
• Out Port—The hardware output port or software virtual output port to which
you are sending the note.
• Vel+—Apply a velocity offset setting to an individual mapped pitch.
• V Scale—The V Scale value sets a level of compression or expansion. A value
below 100% is compression. A value above 100% is expansion. The Vel+
setting allows for gain make-up.
Ports and Channels
This section lists each unique Port and Channel pairing. This allows you to make
quick global changes that Port and Channel pairing’s bank and patch settings.
Working in the Drum Map Manager
The following table lists several ways of editing settings in the Drum Map
Manager.
To do this… Do this…
Audition a row Select the row and press Shift+Spacebar
Sort rows Drag and drop a row to a new location
Select multiple rows Click a row, hold down the Ctrl key while
selecting additional rows
Change the Output Port for all rows
with the same Channel/Port
Press Ctrl+Shift while changing the port.
Undo an edit Press the Undo button